NDT for Aerospace industry

TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm

Ultrasonic inspection of multi-pass welds after each welding pass at temperature up to 200⁰C.

Semi-automated camera-encoded cells designed for inspection of composite parts when an automated system isn’t practical and manual inspections are too time consuming.

Automated robotic systems designed for inspection of large composite parts and forgings.

Automated Electrical Conductivity Measurement System for Plates

Volumetric inspection of laminated strip for coin stock, bearings and similar multi-layered materials.

Uses ultrasonic surface waves for automatic surface inspection of ferrous and non-ferrous flat products.

Full volumetric inspection of rods. Detects longitudinal defects and inclusions. Well suited for copper, steel and other metals.

Stress measurement on railroad wheels, pipelines and plates.

Bolt-load measurement without couplant

High performance immersion tanks for unique Ultrasonic and Phased Array inspections.

Guided wave technique used to inspect thin materials such as aircraft skin and thin, laminated composites, from 0.5mm (0.020") to 6mm (0.25").

Fast inspection for detection of surface defects on most metallic materials.

Non-contact measurements from -30ºC to 650ºC without couplant, fast scanning, with EMAT. High-accuracy thickness measurement for metals and non-metals without couplant with DCUT.

Bolt load inspection without couplant

Stress measurement on railroad wheels, pipelines and plates