NDT for Oil & Gas Industry

TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm

Weld inspection for longitudinal ERW pipe immediately after welding

Ultrasonic Phased Array inspection of linear welds on SAW and ERW pipes and tubes.

Ultrasonic inspection of multi-pass welds after each welding pass at temperature up to 200⁰C.

Provides surface and near-surface inspection of long products (round, square and tubes). Better accuracy than MFL at a fraction of the cost.

Stress measurement on railroad wheels, pipelines and plates.

Bolt-load measurement without couplant

Uses axial scanning of free standing pipes with none or light coatings (<3-4mm) for fast and accurate defect detection around the circumference.

Uses axial scanning to find corrosion under supports when the pipe is accessible from the top.

Side –circumferential- scanning is used for detection of defects on inaccessible areas up to 3m (10’) from the sensor.

Fast plate and tank inspection covering up to 1m (3’) per pass.

Fast inspection for detection of surface defects on most metallic materials.

LRUT provides inspection of long range of pipes up to 100m for a faster screening of large distances of pipes.

Non-contact measurements from -30ºC to 650ºC without couplant, fast scanning, with EMAT. High-accuracy thickness measurement for metals and non-metals without couplant with DCUT.

Bolt load inspection without couplant

Thickness measurement of boiler tube walls, HCC detection.

Stress measurement on railroad wheels, pipelines and plates