WELDs

The following systems incorporate customized hardware, sensors and software for integrated ultrasonic weld inspection applications (in-line or off-line). The list below covers the most common applications.

Tailor Welded Blanks (EMAT)

Tailor Welded Blanks (EMAT)

Industry standard for volumetric inspection of tailor welded blanks. Detects surface and internal defects at production speeds.

Coil Welds in Mill Finishing Lines (EMAT)

Coil Welds in Mill Finishing Lines (EMAT)

The TEMATE SI-MWC and TEMATE SI-LC are designed for automated inspection of Mash Welds and Laser Welds

Thin Butt Welds - Less than 6mm (EMAT)

Thin Butt Welds - Less than 6mm (EMAT)

TEMATE SI-BW is designed for inspection of thin butt welds less than 12mm

Flash-Butt Welds in Steel Mills (EMAT)

Flash-Butt Welds in Steel Mills (EMAT)

Weld inspection in pickle lines without additional cycle time. Detects defects caused by misalignment, poor trimming, and welder failures.

In-Line ERW Tubes (EMAT)

In-Line ERW Tubes (EMAT)

Weld inspection for longitudinal ERW pipe immediately after welding

ERW and SAW Tube and Pipe (PAUT)

ERW and SAW Tube and Pipe (PAUT)

Ultrasonic Phased Array inspection of linear welds on SAW and ERW pipes and tubes.

Inspection of Multi-Pass Welds (EMAT)

Inspection of Multi-Pass Welds (EMAT)

Ultrasonic inspection of multi-pass welds after each welding pass at temperature up to 200⁰C.